How to Roll a Diamond Joint

This one’s a bit tricky, but if you get it right it’s a proper party attraction!

You will need:

• Kingsize rolling papers
• Roach material
• Herb and tobacco mix
• Grinder

Step-by-Step:

1. Make 1 big fat joint with a roach and then cut in half, horizontally.
   
   
2. Make 2 thinner joints that are exactly the same size and consistency. They have to burn at the same rate so it’s crucial to get this right.
   
   
3. Cut away any excess paper from the ends of all the joints.
   
   
   
4. Tear off the gum strips from several spare papers. The longer and thicker, the better.
   
   
5. Very carefully attach the slim joints to one end of the original fat joint. Wrap the spare gum strips around the intersection, making sure it is airtight and secure.
   
   
6. Very, very carefully, bend the two slim joints into a diamond shape so that they can be attached to the other end of the fat joint. Again, use gum strips to secure the intersection.
   

If you like this article, you can find loads more tips and tricks about the art of joint rolling in these fantastic books: The Joint Rolling Handbook & The Joint Rolling Handbook 2, available at all good headshops.